BIGTREETECH Octopus V1.1 Control Board 32Bit Silent Motherboard Support 8 Axis TMC2209 Stepper Motor Driver Compatible BTT Pi V1.2/Pi 2 to Running Klipper/Marlin for Voron 2.4/CoreXY/VZbot 3D Printer
Visit the BIGTREETECH Direct Store
$53.99Buy It Now
| Brand | BIGTREETECH Direct |
| Rating | 4.4 (93 ratings) |
| Price | $53.99 |
| Category | 3D Printer Controllers |
Features
- Main Control Chip: BIGTREETECH Octopus V1.1 control board adoptes ARM Cortex-M4 series STM32F446ZET6 32-bit microcontroller at 180MHz with 512Kb flash ROM. Notice: Input voltage only supports 24V, 12V is not allowed
- CAN BUS: BIGTREETECH Octopus V1.1 32bit control board supports CAN Bus connectivity using an ethernet connector. This CAN Bus connection allows to expand control board with other expansion boards very easily (Notes: Some packages come with a free RJ11 cable, due to the RJ11 cable error, please purchase it separately if you need it)
- 6 PWM Fans Plus 2: The Octopus V1.1 Mainboard offers up to 6 controllable PWM fans and additional 2 without control with the possibility of voltage selection from 5V, 12V or 24V. The BTT Octopus also has 8 sockets for drivers, making it an ideal electronics for demanding machines
- Supports Klipper/Marlin: BIGTREETECH Direct Octopus V1.1 32bit control board compatible with BTT Pi V1.2/Pi 2, supports running Klipper and Marlin, supports firmware update by USB (recommended) and DFU mode(advanced users). Updating via DFU mode is to send firmware to the board directly from PC with no need for bootloader, which is not recommended for novice users
- Type C powers the MCU: Plug the jumper cap into the 5V USB power supply port of the motherboard. You can use the Type C interface to power the motherboard, which makes it easier for the computer to program firmware. If the jumper cap is pulled out, the switching power supply must be turned on when the motherboard is connected to the PC
- Multifunctional interface: BTT Octopus V1.1 control board support Eddy V1.0, BLTOUCH, Microprobe auto bed leveling sensor, SFS V2.0 smart filament runout, power loss detection, CEB V1.0, SKSM V1.0, automatic power down. Display support TFT35 E3 V3.0.1/TFT35 V3.0/TFT50/70. When running Klipper touch mode, please choose HDMI5 V1.2 Touchscreen